At present, we use a lot of baby diaper making machine in the market, but different manufacturers of equipment, each equipment has its own use method, if not used properly, will cause damage to the equipment. Today, a brief introduction to the use of infant diaper machine and precautions, I hope it will be helpful to you.
1. Start baby diaper making machine correctly
The correct start of baby diaper making machine has a direct impact on the service life of the machine. When starting, from the crankshaft began to rotate to the oil reaches the cylinder wall time is about 1 min ~ 4 min. between the friction surface lack of sufficient lubricating oil film, and the new oil film needs to be formed within a certain period of time after the start, the piston ring and cylinder wall and other parts of the metal surface dry friction, greatly accelerating the cylinder wall and piston ring wear. The lower the temperature before starting, the greater the wear. Lubricating oil in low temperature viscosity, poor fluidity, not easy to enter the friction surface, it is difficult to ensure lubrication. In addition, at the beginning of the start, not atomized fuel, along the cylinder wall and piston flow between the oil sump, wash away the only remaining oil film between the two, resulting in increased wear.
2. Avoid the explosion of baby diaper making machine
baby diaper making machine oil supply time is too early, too much carbon in the combustion chamber, the working temperature is too high is the main reason for deflagration. When there is a deflagration, it is easy to cause a sharp rise in the internal temperature of the combustion chamber and the local gas pressure in the cylinder is too large. Combustion chamber internal temperature rises sharply, easy to make the piston, valve and other parts overheating or ablation; cylinder local gas pressure is too large, easy to make the piston, cylinder wall, connecting rod and crankshaft to bear a large impact load and damage.
3. Prevent the overload operation of baby diaper making machine
Baby diaper making machine overload operation has a greater impact on wear and tear. When the speed is low, it is difficult to form a good lubricating oil film between the matching parts, so that the lubrication conditions become poor, and the parts wear larger. With the increase of speed, the lubricant film formation is better, and the wear will be gradually reduced. However, when running at high speed, it is difficult to form a good lubricating oil film between the mating parts, so that the lubrication conditions become poor, and the parts wear more. At the same time, high speed operation, the temperature between the parts of the machine to reduce the viscosity of the oil, oil film formation is poor, so that the wear increased sharply.
4. Keep the baby diaper making machine running at room temperature
When the temperature of baby diaper making machine is too high, it will cause the metal expansion to increase, destroy the normal fit gap, and easily produce piston bite, cylinder pulling and other hazards. At the same time, the temperature is too high also easy to make the oil thin, accelerate the oil oxidation deterioration, intensify the cylinder wear. When the temperature is too low, the lubricating oil is viscous at low temperature, poor fluidity, not easy to enter the friction surface, difficult to ensure lubrication, intensify wear. Therefore, do not remove the thermostat or block the small circulation pipe. Otherwise, it will cause the cylinder wall to lose too much heat, reduce the thermal efficiency and affect the normal work. At the same time, the oil temperature is too low easy to make the oil viscosity becomes large, the running resistance of the machine increases, intensify the wear of the machine, reduce the power, economy, shorten the service life of machinery.
As long as the importance and implementation of the requirements of the baby diaper making machine maintenance and maintenance, will reduce the occurrence of early failure, extend the service life, improve operational efficiency, so that the machine for you to bring more revenue.
